Saturday, February 22, 2014
Tuesday, February 18, 2014
Wednesday, February 12, 2014
FreePBX as SBC, CUBE, Session mgr...whatever you want to call it...for CUCM v8.6
Yes, it works....for lab/personal use only and at your own risk, but it DOES work.
I am using a FreePBX asterisk box to connect my lab Cisco CUCM to a SIP provider.
I am using a FreePBX asterisk box to connect my lab Cisco CUCM to a SIP provider.
Sunday, February 09, 2014
RC66RX and Pioneer VSX108
Pioneer VSX-108 VSX 108 Audio
Move mode to AV1
Mute-Select
Code for DirecTV is 31123
(Then Select I think)
and then mute-select 993 SELECT to lock it as the volume control.
Programming via the screen is worthless
END of Story.
Move mode to AV1
Mute-Select
Code for DirecTV is 31123
(Then Select I think)
and then mute-select 993 SELECT to lock it as the volume control.
Programming via the screen is worthless
END of Story.
Saturday, February 01, 2014
SIP Trunk between CUCM 8.6 and Trixbox v2.8.0.4
WORKS! Make sure you are using a SIP Security Profile with only UDP for Outgoing Transport Type.
That was killing me till I found that on some other sites.
Here's the Trixbox side...
On the CUCM side, it's easy. Just set up a SIP Security Profile with UDP for Outgoing Transport Type and configure a SIP trunk with it. Make sure you have a Media Resource Group List with an MTP in it...at least that's what I read. A discussion of MTPs is too much for here. For my little set up with a couple of phones, the software MTP in CUCM will be fine.
I picked the defaults for nearly everything else on the trunk configuration.
That was killing me till I found that on some other sites.
Here's the Trixbox side...
On the CUCM side, it's easy. Just set up a SIP Security Profile with UDP for Outgoing Transport Type and configure a SIP trunk with it. Make sure you have a Media Resource Group List with an MTP in it...at least that's what I read. A discussion of MTPs is too much for here. For my little set up with a couple of phones, the software MTP in CUCM will be fine.
I picked the defaults for nearly everything else on the trunk configuration.
Subscribe to:
Posts (Atom)